Zenith z50px2d repair manual

Previous Page. Next Page. Zenith installation and operating guide plasma tv 60 pages. Page 4 Safety Instructions IOnS 13, Unplug this apparatus during lightning storms or when unused for long periods of time. Refer all servicing to qualified service personnel.

Manual Sound Control Custom Option.. Front Surround Safety Instructions Connection Options A plasma display panel is the latest display technology and the best way to achieve flat panef displays with excellent image quality and large screen sizes that are easily viewabie The PDP can be thought of as a descendant of the neon lamp and it can be also be viewed as a series of fluorescent lamps, How does it work?

Page 7 Introduction This is a simpFified representation of front pane]. Here shown may be somewhat different from your TV. Page 9 introduction When using the remote control, aim it at the remote control sensor on the TV.

Turns your TV or any other programmed equipment Page 11 Installation Ensure that the following accessories are included with your plasma display. Page 15 Installation to connect Connect the audio and video cables from the externa] equip- ment's output jacks to the TV input jacks, as shown in the figure. Page 24 Operation There are two different ways in order to add or delete scanned channels.

A Custom List can be created by toggling each channel Press the MENU button and then use a. Page To Select Operation Set up blocking schemes to block specific channels, ratincss, and external viewing sources. A password is required to gain access to this menu. Page 39 Operation Brief Info. Brief Into shows the present screen [rfformation. Mute Off : Sound is enabled.

Page 42 Extema! Page 44 External Control Device Setup If the device is not responding check the batteries in the remote it may be that batteries are exhausted. Use the remote control's mode buttons to set the remote to the correct mode for the equipment.

Be sure to program the remote control to operate the other equipment as described on manual. To change the mode, press the button for the equipment you want to control. The mode button lights for three seconds to show you've set the remote to that mode. Depending on how the remote is set up, the remote control may use UHF radio signals, IR signals, or both to control the receiver. However, only IR signals are used to control other equipment. IR signals travel short distances generally 20 feet or 7 meters they can go up to 40 feet, and cannot go through walls or other solid objects.

Point the remote control directly at the equipment you want to control, with no objects to block the signal path. This manual shows you how to program the remote control to operate a TV. The following section uses a different method to program the remote control to operate a TV or other equipment such as a DVD player or VCR, tuner, amplifier, audio receiver or a second TV.

You can program the remote control by either following the instructions in Programming Using Equipment Remote Code Tables, or the Scanning for Equipment Codes procedure. Denon Soundbar.